Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   + 9.2. Coupling
   + 9.3. A kardannyj shaft
   - 9.4. Power shafts
      9.4.1. A forward power shaft
      9.4.2. A back power shaft (models 4WD)
      - 9.4.3. Replacement of protective covers of hinges of equal angular speeds
         9.4.3.1. The hinge with balls and a separator
         9.4.3.2. The trehplechy hinge with rollers
      9.4.4. The external hinge of a power shaft
      9.4.5. Replacement of sealing rings of back differential
      9.4.6. Back main transfer
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

9.4.3.2. The trehplechy hinge with rollers
THE GENERAL DATA

Forward power shaft with трехплечим the hinge with rollers on models since 1994

1 – a sealing ring
2 – a ring
3 – a spring pin
4 – the case of the internal hinge
5 – a lock ring
6 – the spherical hinge
7 – rollers
8 – a fixing ring
9 – collars
10 – a protective cover internal
The hinge
11 – a protective cover of the external hinge
12 – the external hinge
13 – a ring

Dismantling

PERFORMANCE ORDER
1. Remove a power shaft.
2. Fix a power shaft in a vice with soft sponges.
3. Remove collars of fastening of a protective cover of a power shaft.
4. Take fixing ring.
5. Remove the case of the internal hinge of a power shaft.
6. Remove greasing from details of the hinge of equal angular speeds and, using a paint or a chalk, put combination labels on the case of the hinge and трехплечий the hinge.
7. Remove a lock ring from the end of a power shaft and note mutual position of a power shaft and трехплечего the hinge.
8. Fix rollers of the hinge a sticky tape, then remove трехплечий the hinge from a power shaft.
9. Remove a protective cover of a power shaft.

Check

PERFORMANCE ORDER
1. Carefully wash out solvent all details of the hinge until old greasing of the hinge will not be completely removed.
2. Check up all details of the hinge on absence of cracks, dredging, задиров, dot corrosion and abnormal deterioration.

Assemblage

PERFORMANCE ORDER
1. Roll up a sticky tape шлицы a power shaft and pull over a power shaft a new protective cover.
2. Remove a sticky tape.
3. Establish трехплечий the hinge on a power shaft, thus earlier put labels on the hinge and to a shaft should be combined.
4. Establish a lock ring.
5. Put on bearings of rollers a layer of greasing and establish rollers on an axis трехплечего the hinge.
6. Enclose half of demanded quantity of greasing in the case of the internal hinge and establish the hinge case on трехплечий the hinge.
7. At installation of the case of the hinge check up, that the adjusting labels put at removal of the case, have coincided.
8. Establish a protective cover and fix its collars.
9. Establish a power shaft.