Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   + 9.2. Coupling
   + 9.3. A kardannyj shaft
   - 9.4. Power shafts
      9.4.1. A forward power shaft
      9.4.2. A back power shaft (models 4WD)
      + 9.4.3. Replacement of protective covers of hinges of equal angular speeds
      9.4.4. The external hinge of a power shaft
      9.4.5. Replacement of sealing rings of back differential
      9.4.6. Back main transfer
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d Стоматологическая поликлиника тимирязевская посмотреть.
e2a7ff6d Стоматологическая поликлиника тимирязевская посмотреть.

9.4.2. A back power shaft (models 4WD)
PERFORMANCE ORDER
1. Ослабьте a nut of fastening of a power shaft to a nave of a back wheel.
2. Lift a back part of the car and remove a back wheel.
3. Remove gauge ABS and disconnect a cable of a manual brake from a back brake board.
4. Unscrew bolts, крепящие levers of a back suspension bracket to a fixing element of a nave.
5. Unscrew a nut of fastening of a power shaft to a nave.
6. Take away a nave from the car and take the external end of a power shaft from a nave.
7. If the power shaft densely sits in a nave, temporarily screw a nut of a nave and, using a hammer, beat out a power shaft from a nave, simultaneously tightening a car wheel outside.
8. On early models by means of corresponding выколотки beat out a cylindrical pin, крепящий a power shaft to the main transfer.
9. Using mount, remove back приводной a shaft from the main transfer.
10. On later models insert between an internal SHRUS and the main transfer mount and, at that time when the assistant will pull a power shaft outside, strong sharp blow on the mount end beat out a power shaft from gearing in a semiaxial gear wheel of differential.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Grease grooves of a shaft with greasing on a basis дисульфида molybdenum. For power shaft fastening to the main transfer use new pins.
3. Tighten all nuts and bolts the demanded moment. Replace a nut of fastening of a power shaft to a nave.