Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   + 9.2. Coupling
   + 9.3. A kardannyj shaft
   - 9.4. Power shafts
      9.4.1. A forward power shaft
      9.4.2. A back power shaft (models 4WD)
      + 9.4.3. Replacement of protective covers of hinges of equal angular speeds
      9.4.4. The external hinge of a power shaft
      9.4.5. Replacement of sealing rings of back differential
      9.4.6. Back main transfer
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

9.4.1. A forward power shaft

Removal

PERFORMANCE ORDER
1. Remove a decorative cap of a wheel.
2. Using выколотку, unbend fixing fillet of a nut of fastening of a power shaft to a nave.
3. Ослабьте, but do not unscrew a nut of fastening of a power shaft to a nave.

The prevention

Do not unscrew a nut of fastening of a power shaft to a nave if car wheels stand on the earth as in this case nave bearings will be damaged.


4. Lift a forward part of the car and fix on supports. Remove a wheel.
5. Unscrew a nut, крепящую steering bent for to a rotary fist and, using a stripper of spherical hinges, remove steering draught from a rotary fist.
6. Unscrew tightening a bolt, крепящий the bottom lever of a suspension bracket to a rotary fist.
7. Using a flat chisel or a screw-driver edge as a wedge, unclench a clip of the spherical hinge in the bottom part of a rotary fist.
8. Using the lever, move the bottom lever of a suspension bracket downwards for extraction of the spherical hinge from a rotary fist.
9. Unscrew a nut of fastening of a power shaft to a nave.
10. Take away a nave from the car and take the external end of a power shaft from a nave.
11. If the power shaft densely sits in a nave, temporarily screw a nut of a nave and, using a hammer, beat out a power shaft from a nave, simultaneously tightening car wheels outside.
12. By means of corresponding выколотки beat out a cylindrical pin, крепящий a power shaft to a transmission.
13. Remove the internal hinge of a power shaft from a transmission shaft.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Grease шлицы a shaft with greasing on a basis дисульфида molybdenum.
3. Tighten all nuts and bolts the demanded moment.
4. Replace a nut of fastening of a power shaft to a nave.