Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. A coupling cable
      9.2.2. The main cylinder of coupling
      9.2.3. The working cylinder of coupling
      9.2.4. A coupling disk
      9.2.5. The vyzhimnoj bearing
      9.2.6. Replacement of the needle bearing of a target shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. A kardannyj shaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

9.2.8. The switch of blocking of a starter on a coupling pedal
THE GENERAL DATA

Arrangement of the switch of blocking of a starter on a coupling pedal


The switch of blocking of a starter on a coupling pedal is located on an arm in the top part of a pedal of coupling.

Check

PERFORMANCE ORDER
For switch check disconnect from the switch an electric socket and connect to contacts of the switch an ohmmeter and check up that by pressing of a pedal of coupling switch contacts become isolated, and at installation of a pedal of coupling in a starting position switch contacts are disconnected.

Replacement

PERFORMANCE ORDER
1. Disconnect from the switch an electric socket unscrew a nut of fastening of the switch and take the switch from an arm.
2. At installation of the new switch establish an adjusting nut on the same distance from the switch case, as well as on earlier removed switch.
3. Establish the switch in an arm and fix a nut.
4. Check up work of the switch and, in need of adjustment, rotating adjusting and adjusting nuts, adjust switch position.
5. Connect an electric socket to the switch.