Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. A coupling cable
      9.2.2. The main cylinder of coupling
      9.2.3. The working cylinder of coupling
      9.2.4. A coupling disk
      9.2.5. The vyzhimnoj bearing
      9.2.6. Replacement of the needle bearing of a target shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. A kardannyj shaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

9.2.7. Removal of air from hydraulic system of coupling
PERFORMANCE ORDER
1. Unscrew a cover of a nutritious tank and check up, that level of a brake liquid in a tank was up to standard of a label max. At air removal watch liquid presence in a tank, without supposing an exposure of its bottom as thus air again will get to system.
2. Remove a dustproof cap from the union of prorolling and put on it the pure transparent hose which other end is necessary for lowering in the capacity partially filled with a brake liquid.
3. Sharply press a coupling pedal some times with an interval 2–3 seconds Unscrew on half of turn the prorolling union at the pressed pedal. Continuing to press a pedal, supersede a liquid being in system together with air through a hose in capacity. After the pedal will reach extreme forward position, and liquid replacement through a hose will stop, will screw the prorolling union home.
4. Repeat these operations, the air outlet from the union will not stop yet.
5. Keeping a pedal in the pressed position, screw up the prorolling union against the stop and remove a hose.
6. Wipe the union of prorolling and establish a dustproof cap.