Subaru Legacy

Since 1990-1998 of release

Repair and car operation

Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. A coupling cable
      9.2.2. The main cylinder of coupling
      9.2.3. The working cylinder of coupling
      9.2.4. A coupling disk
      9.2.5. The vyzhimnoj bearing
      9.2.6. Replacement of the needle bearing of a target shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. A kardannyj shaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment

схема поплавкового клапана
электромонтаж в квартире
Бесплатная диагностика туарег смотри здесь.
схема поплавкового клапана
электромонтаж в квартире
Бесплатная диагностика туарег смотри здесь.

9.2.6. Replacement of the needle bearing of a target shaft of a transmission

THE GENERAL DATA

The needle bearing of an entrance shaft of a transmission is established in an end face of a cranked shaft.

PERFORMANCE ORDER

1. Remove a transmission.

2. Remove a leading part of coupling and a coupling disk.

3. Take from an aperture in an end face of a cranked shaft the needle bearing by means of a corresponding stripper.

4. Using tubular оправку the corresponding diameter, establish the new needle bearing in an aperture in an end face of a cranked shaft.

5. Establish a disk of coupling and press a disk. Establish a transmission.