Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. A coupling cable
      9.2.2. The main cylinder of coupling
      9.2.3. The working cylinder of coupling
      9.2.4. A coupling disk
      9.2.5. The vyzhimnoj bearing
      9.2.6. Replacement of the needle bearing of a target shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. A kardannyj shaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


9.2.5. The vyzhimnoj bearing Removal

PERFORMANCE ORDER
1. Remove a transmission.
2. Remove скобы fastenings выжимного the bearing.
3. Remove выжимной the bearing from an entrance shaft of a transmission.
4. Having pulled a plug of deenergizing of coupling, remove it from a spherical head of a support of the lever.
5. Remove a rubber cover and through an aperture in картере couplings take a plug of deenergizing of coupling.

Check

PERFORMANCE ORDER
1. Keeping the bearing for an external holder, pressing, turn an internal holder of the bearing. If the bearing rotates with noise and non-uniformly, replace выжимной the bearing.
2. Wipe the bearing pure rags and check up its condition on presence of damages, deterioration and a crack. Do not wash out the bearing in solvent as it is the bearing of the closed type.

Installation

PERFORMANCE ORDER
1. Put high-temperature greasing on a head of a pusher of the cylinder of deenergizing of coupling.
2. Put high-temperature greasing on directing plug выжимного the bearing.
3. Put high-temperature greasing on working surfaces of a plug of deenergizing of coupling.
4. Put high-temperature greasing on a spherical nest of a plug of deenergizing of coupling.
5. Installation is made in sequence, return to removal.