Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. A coupling cable
      9.2.2. The main cylinder of coupling
      9.2.3. The working cylinder of coupling
      9.2.4. A coupling disk
      9.2.5. The vyzhimnoj bearing
      9.2.6. Replacement of the needle bearing of a target shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. A kardannyj shaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

9.2.3. The working cylinder of coupling

Removal

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Lift the car and fix on supports.
3. Unscrew a bolt and remove a hydraulic hose from the working cylinder of coupling. Merge a brake liquid in the suitable container.
4. Unscrew bolts and remove the working cylinder of coupling.

Installation

PERFORMANCE ORDER
1. Establish the working cylinder of coupling on картере couplings. Check up that the pusher was established in dredging of a plug of deenergizing of coupling.
2. Using new sealing washers, connect a hydraulic hose to the working cylinder of coupling.
3. Fill the main cylinder of coupling with a brake liquid.
4. Remove air from hydraulic system of coupling.
5. Lower the car and connect a weight wire to the accumulator.