Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. A coupling cable
      9.2.2. The main cylinder of coupling
      9.2.3. The working cylinder of coupling
      9.2.4. A coupling disk
      9.2.5. The vyzhimnoj bearing
      9.2.6. Replacement of the needle bearing of a target shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. A kardannyj shaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

9.2.2. The main cylinder of coupling

Removal and installation

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Disconnect a pusher of the main cylinder of coupling from a coupling pedal. Unscrew a bolt, disconnect a hydraulic hose from the main cylinder of coupling and merge a brake liquid in the suitable container.
3. Unscrew nuts of fastening of the main cylinder of coupling to a partition of a motor compartment and remove the main cylinder of coupling.
4. Installation is made in sequence, return to removal. Remove air from hydraulic system of coupling and check up height of installation and a free wheeling of a pedal of coupling.