Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. A coupling cable
      9.2.2. The main cylinder of coupling
      9.2.3. The working cylinder of coupling
      9.2.4. A coupling disk
      9.2.5. The vyzhimnoj bearing
      9.2.6. Replacement of the needle bearing of a target shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. A kardannyj shaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


9.2.1. A coupling cable
THE GENERAL DATA

Check of a free wheeling of a pedal of coupling

Check

For check of adjustment of a cable of coupling, check up a free wheeling of a pedal of coupling. The free wheeling of a pedal of coupling is a course of a pedal from a starting position till the moment of occurrence of appreciable resistance by pedal pressing. If the free wheeling of a pedal of coupling does not correspond to requirements, make adjustment of a cable of coupling.

Adjustment

PERFORMANCE ORDER
1. Disconnect a returnable spring from a plug of deenergizing of coupling.
2. Ослабьте a counternut on the end of a cable of coupling in a plug of deenergizing of coupling.
3. Rotating an adjusting nut, adjust free and a full speed of a plug of deenergizing of coupling.
4. Tighten a counternut.
5. Establish a returnable spring on a plug of deenergizing of coupling.

Replacement

PERFORMANCE ORDER
1. Remove a returnable spring from a plug of deenergizing of coupling.
2. Unscrew a counternut and an adjusting nut from the end of a cable of coupling.
3. By means of flat-nose pliers remove U-shaped скобу, which крепит a cover of a cable of coupling to an arm.
4. Remove a cable of coupling from an arm.
5. In car salon on the top part of a pedal of coupling remove шплинт (2), take a pin (1) and remove a cable of coupling (3) from a coupling pedal.
6. Take a coupling cable through a partition of a motor compartment in a motor compartment.
7. Installation is made in sequence, return to removal. Adjust a coupling cable.