Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
- 8. Transmissions
   + 8.1. A mechanical transmission
   - 8.2. An automatic transmission
      8.2.1. Introduction
      8.2.2. Technical characteristics
      8.2.3. Diagnostics of leak of operational liquids
      8.2.4. The lever and a gear change cable
      8.2.5. A cable of a choice of transfers
      8.2.6. The switch of blocking of a starter and backing light
      8.2.7. Replacement of sealing rings
      8.2.8. Check and replacement of support of a transmission
      8.2.9. Adjustment of a brake tape
      8.2.10. Removal and transmission installation
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


8.2.9. Adjustment of a brake tape
THE GENERAL DATA

Arrangement of the adjusting screw for adjustment люфта a brake tape

The adjusting screw for adjustment люфта a brake tape is located on a transmission left-hand side.

In movement check up work of an automatic transmission and pay attention to the following:

If transmission switching on more higher transfer occurs directly from the first transfer to the third, a backlash of a brake tape too high. Tighten the adjusting screw of a brake tape.
If engine turns sharply increase at switching of a transmission with the first by the second or about the third on the fourth transfers or there is a big delay at switching on the lowest transfers, люфт a brake tape too big. Slightly tighten the adjusting screw of a brake tape.
If braking at transmission switching on higher transfer, for example, with the second on the third, люфт a brake tape too small is observed. Slightly ослабьте the adjusting screw.
If the transmission is repeatedly switched through one transfer, for example, with the second to the fourth or with the fourth on the second, люфт a brake tape too small. Ослабьте the adjusting screw of a brake tape.
PERFORMANCE ORDER
1. Lift the car and fix on supports.
2. Keeping a wrench the adjusting screw from проворачивания, the second key ослабьте a counternut and after turn of the adjusting screw repeatedly tighten a counternut.