Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
- 8. Transmissions
   + 8.1. A mechanical transmission
   - 8.2. An automatic transmission
      8.2.1. Introduction
      8.2.2. Technical characteristics
      8.2.3. Diagnostics of leak of operational liquids
      8.2.4. The lever and a gear change cable
      8.2.5. A cable of a choice of transfers
      8.2.6. The switch of blocking of a starter and backing light
      8.2.7. Replacement of sealing rings
      8.2.8. Check and replacement of support of a transmission
      8.2.9. Adjustment of a brake tape
      8.2.10. Removal and transmission installation
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

8.2.6. The switch of blocking of a starter and backing light
THE GENERAL DATA

Arrangement of contacts on an electric socket of the switch of blocking of a starter and backing light on early models



Arrangement of contacts of an electric socket of the switch of blocking of a starter and backing light on late models


Condition of contacts of the switch of blocking of a starter and light of a backing depending on position of the lever of a choice of transfers

Check

Check up that engine start is possible only in position PARK or NEUTRAL the lever of a choice of transfers and that backing lanterns join only at reverse gear inclusion.

Adjustment

PERFORMANCE ORDER
1. Lift the car and fix on supports.
2. Disconnect an electric socket from the switch.
3. Ослабьте bolts of fastening of the switch of blocking of a starter and backing light (are specified by arrows).
4. Connect an ohmmeter to corresponding contacts of an electric socket of the switch and move the switch to such position when there will be a disconnection of contacts of the switch of blocking of a starter (see fig. the Arrangement of contacts an electric socket of the switch of blocking of a starter and backing light on early models, fig. the Arrangement of contacts of an electric socket of the switch of blocking of a starter and backing light on late models, fig. the Condition of contacts of the switch of blocking of a starter and light of a backing depending on position of the lever of a choice of transfers).
5. Tighten bolts of fastening of the switch.

Replacement

PERFORMANCE ORDER
1. Lift the car and fix on supports.
2. Disconnect an electric socket from the switch.
3. Disconnect a cable of a choice of transfers from the lever on a transmission.
4. Unscrew a nut, крепящую the lever of a choice of transfers to a shaft on a transmission.
5. Remove the lever from a shaft.
6. Unscrew bolts and remove the switch of blocking of a starter and backing light.
7. Installation is made in sequence, return to removal.