Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
- 7. Systems of start, ignition
   7.1. Introduction
   7.2. Technical characteristics
   7.3. Accumulator check
   7.4. Accumulator gymnastics
   7.5. The accumulator
   + 7.6. Ignition system
   - 7.7. Gymnastics system
      7.7.1. The generator
      7.7.2. Repair and generator check
   + 7.8. System of start of the engine
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


7.7.1. The generator
THE GENERAL DATA

The generator established on the engine of 1,8 l

1 – a pulley
2 – a forward cover
3 – the bearing
4 – a plate of fastening of the bearing
5 – a rotor
6 – статор
7 – a bolt
8 – a pressure regulator
9 – brushes
10 – a plate with diodes
11 – the condenser
12 – a back cover

The generator established on engines 2,0, 2,2 and 2,5 l

1 – a nut
2 – a pulley
3 – a forward cover
4 – the bearing
5 – a plate of fastening of the bearing
6 – the screw
7 – a rotor
8 – статор
9 – a pressure regulator
10 – the condenser, brushes
11 – a plate with diodes
12 – a bolt
13 – a bolt
14 – щеткодержатель
15 – a back cover
16 – contact
17 – a nut
18 – a bolt
19 – a coupling bolt

Removal and installation

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Disconnect electric sockets from the generator.
3. Remove приводной a generator belt.
4. Unscrew adjusting and шарнирные bolts (fastenings of the generator are specified by arrows) and remove the generator from the engine.
5. Installation is made in sequence, return to removal. Adjust a tension приводного a belt.