Subaru Legacy

Since 1990-1998 of release

Repair and car operation


Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
- 7. Systems of start, ignition
   7.1. Introduction
   7.2. Technical characteristics
   7.3. Accumulator check
   7.4. Accumulator gymnastics
   7.5. The accumulator
   - 7.6. Ignition system
      7.6.1. Check of system of ignition
      7.6.2. The ignition coil
      7.6.3. Check of a corner of an advancing of ignition
      7.6.4. Replacement of the block of ignition
   + 7.7. Gymnastics system
   + 7.8. System of start of the engine
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d

7.6.1. Check of system of ignition
THE GENERAL DATA

Fastening of the tyre of grounding about the ignition coil

PERFORMANCE ORDER
1. If the engine is turned by a starter, but not started, disconnect a wire from any spark plug and connect to an autotester. Connect an autotester clip to a bolt or to a metal arm of the engine.
2. In the absence of an automobile tester for check of system of ignition remove a high-voltage wire from any candle and, using the tool with the isolated handles, approach the end of a high-voltage wire on 6 mm to the block of cylinders of the engine.
3. Turning the engine a starter, observe of an automobile tester or the end of a high-voltage wire to notice a spark at work of system of ignition.
4. If the spark is present, means, on a candle sufficient pressure moves.
5. If the spark is absent, remove from the ignition coil an electric socket and, having included ignition, check up pressure on contacts of an electric socket.
6. If the spark still is absent or spark admissions are observed, check up reliability of connection of the tyre of grounding (fig. Fastening of the tyre of grounding about the ignition coil see).