Subaru Legacy

Since 1990-1998 of release

Repair and car operation

Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. An exhaust system
   6.1. Service of final system
   - 6.2. Reduction of toxicity of exhaust gases and management of engine work
      6.2.1. Technical characteristics
      6.2.2. Self-diagnostics system (OBD) and codes
      6.2.3. The electronic control block (ECM)
      6.2.4. The gauge of temperature of a cooling liquid
      6.2.5. The gauge of position throttle заслонки
      6.2.6. Gauges of a cranked shaft, a camshaft, speed of the car
      6.2.7. The oxygen gauge
      6.2.8. The gauge of a stream of air
      6.2.9. The detonation gauge
      6.2.10. The pressure gauge in an inlet collector
      6.2.11. Replacement of the gauge of temperature of a cooling liquid
      6.2.12. Replacement of the gauge of a stream of air
      6.2.13. Replacement of the gauge of oxygen
      6.2.14. Replacement of the gauge of position throttle заслонки
      6.2.15. Replacement of the gauge of an angle of rotation of a cranked shaft
      6.2.16. Replacement of the gauge of position of a camshaft
      6.2.17. Replacement of the gauge of a detonation
      6.2.18. Replacement of the gauge of speed of the car
      6.2.19. Replacement of the gauge of pressure
      6.2.20. System of repeated burning of the fulfilled gases (EGR)
      6.2.21. System of catching of steams of fuel (EVAP)
      6.2.22. System of compulsory ventilation картера (PCV)
      6.2.23. The catalyst
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment

Внутренние геморроидальные узлы операция.
Внутренние геморроидальные узлы операция.

6.2.15. Replacement of the gauge of an angle of rotation of a cranked shaft

THE GENERAL DATA

Arrangement of the gauge of an angle of rotation of a cranked shaft

The gauge of an angle of rotation of a cranked shaft (it is specified by an arrow) is established on a casing of the oil pump about a pulley of a cranked shaft.

PERFORMANCE ORDER

1. Unscrew a bolt of fastening of the gauge and remove the gauge.

2. Installation is made in sequence, return to removal.