Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. An exhaust system
   6.1. Service of final system
   - 6.2. Reduction of toxicity of exhaust gases and management of engine work
      6.2.1. Technical characteristics
      6.2.2. Self-diagnostics system (OBD) and codes
      6.2.3. The electronic control block (ECM)
      6.2.4. The gauge of temperature of a cooling liquid
      6.2.5. The gauge of position throttle заслонки
      6.2.6. Gauges of a cranked shaft, a camshaft, speed of the car
      6.2.7. The oxygen gauge
      6.2.8. The gauge of a stream of air
      6.2.9. The detonation gauge
      6.2.10. The pressure gauge in an inlet collector
      6.2.11. Replacement of the gauge of temperature of a cooling liquid
      6.2.12. Replacement of the gauge of a stream of air
      6.2.13. Replacement of the gauge of oxygen
      6.2.14. Replacement of the gauge of position throttle заслонки
      6.2.15. Replacement of the gauge of an angle of rotation of a cranked shaft
      6.2.16. Replacement of the gauge of position of a camshaft
      6.2.17. Replacement of the gauge of a detonation
      6.2.18. Replacement of the gauge of speed of the car
      6.2.19. Replacement of the gauge of pressure
      6.2.20. System of repeated burning of the fulfilled gases (EGR)
      6.2.21. System of catching of steams of fuel (EVAP)
      6.2.22. System of compulsory ventilation картера (PCV)
      6.2.23. The catalyst
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


6.2.11. Replacement of the gauge of temperature of a cooling liquid
THE GENERAL DATA

Arrangement of the gauge of temperature of a cooling liquid

The gauge of temperature of a cooling liquid (it is specified by an arrow) is located on a pipe under an inlet collector.

The prevention

Replacement of the gauge of temperature of a cooling liquid make on the cold engine.


PERFORMANCE ORDER
1. Merge 2–3 l of a cooling liquid from a radiator.
2. Remove from the gauge an electric socket and unscrew the gauge of temperature of a cooling liquid.
3. Before installation of the new gauge wind a carving of the gauge with a teflon tape for hermetic sealing.
4. Installation is made in sequence, return to removal. Add cooling liquid in cooling system.