Subaru Legacy
Since 1990-1998 of release
Repair and car operation
Subaru
Legasi
+
1.1. Identification numbers
+
2. Maintenance service
+
3. Engines
+
4. Heating, ventilation
-
5. Fuel system
5.1. Introduction
5.2. Technical characteristics
5.3. Pressure removal in fuel system
5.4. Check of the fuel pump
5.5. The fuel pump
5.6. A fuel separator (only models 4WD)
5.7. The gauge of level of fuel
5.8. A fuel tank
5.9. A casing of the air filter
5.10. An accelerator cable
5.11. Electronic system of injection of fuel
5.12. Fuel system
5.13. System of giving of air
5.14. Electronic control system
5.15. Check of system of injection of fuel
+
5.16. Check and replacement of elements of system of injection of fuel
5.17.
Турбонагнетатель
5.18. Check of the executive mechanism
заслонки
турбонагнетателя
5.19. The general check
турбонагнетателя
5.20. Removal and installation
турбонагнетателя
+
6. An exhaust system
+
7. Systems of start, ignition
+
8. Transmissions
+
9. Coupling, shaft
+
10. Brake system
+
11. A suspension bracket
+
12. A steering
+
13. A body
+
14. An electric equipment
5.5. The fuel pump
THE GENERAL DATA
Removal of percussion caps of fastening of a carpet for access to a cover of the fuel pump
Arrangement of the gauge of level of fuel and the block of the gauge of level of fuel / of the fuel pump on models 4WD
Removal and installation
PERFORMANCE ORDER
1.
Remove pressure in fuel system. Remove a wire of weight from the accumulator.
2.
Remove a back seat (the car with a body of type "sedan") or a carpet covering (the car with a body "versatile person") for access to a cover of the fuel pump (
Removal of percussion caps of fastening of a carpet for access to a cover of the fuel pump
, fig. the
Arrangement of the gauge of level of fuel and the block of the gauge of level of fuel / of the fuel pump
fig. see
models 4WD
).
3.
Unscrew screws of fastening of a cover of the fuel pump and lift a cover.
4.
Disconnect an electric socket of the fuel pump.
5.
Ослабьте
collars also remove hoses from unions of the fuel pump. On models 4WD also remove a hose of the pumping over pump.
6.
Unscrew bolts of fastening of the fuel pump.
7.
Take assemblage of the fuel pump from a fuel tank.
8.
Disconnect an internal electric socket.
9.
Remove
топливопровод
.
10.
Release fastening and remove the fuel pump.
10.
Installation is made in sequence, return to removal.