Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Pressure removal in fuel system
   5.4. Check of the fuel pump
   5.5. The fuel pump
   5.6. A fuel separator (only models 4WD)
   5.7. The gauge of level of fuel
   5.8. A fuel tank
   5.9. A casing of the air filter
   5.10. An accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of giving of air
   5.14. Electronic control system
   5.15. Check of system of injection of fuel
   - 5.16. Check and replacement of elements of system of injection of fuel
      5.16.1. The throttle case
      5.16.2. A fuel highway
      5.16.3. A regulator of pressure of fuel
      5.16.4. Fuel atomizers (MPFI)
      5.16.5. A fuel atomizer (SPFI)
      5.16.6. The control air valve (IAC)
      5.16.7. The gauge of position throttle заслонки (SPFI)
   5.17. Турбонагнетатель
   5.18. Check of the executive mechanism заслонки турбонагнетателя
   5.19. The general check турбонагнетателя
   5.20. Removal and installation турбонагнетателя
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment










5.16.4. Fuel atomizers (MPFI)

Removal and installation

PERFORMANCE ORDER
1. Remove pressure in fuel system.
2. Disconnect an electric socket from a fuel atomizer.
3. Unscrew screws of a head of a fuel atomizer (are specified by arrows).
4. Turning and having pulled on itself, take a fuel atomizer.
5. Check up a condition of sealing rings of a fuel atomizer (are specified by arrows) and if necessary, replace them.
6. Installation is made in sequence, return to removal. At installation of fuel atomizers oil sealing rings.