Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Pressure removal in fuel system
   5.4. Check of the fuel pump
   5.5. The fuel pump
   5.6. A fuel separator (only models 4WD)
   5.7. The gauge of level of fuel
   5.8. A fuel tank
   5.9. A casing of the air filter
   5.10. An accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of giving of air
   5.14. Electronic control system
   5.15. Check of system of injection of fuel
   - 5.16. Check and replacement of elements of system of injection of fuel
      5.16.1. The throttle case
      5.16.2. A fuel highway
      5.16.3. A regulator of pressure of fuel
      5.16.4. Fuel atomizers (MPFI)
      5.16.5. A fuel atomizer (SPFI)
      5.16.6. The control air valve (IAC)
      5.16.7. The gauge of position throttle заслонки (SPFI)
   5.17. Турбонагнетатель
   5.18. Check of the executive mechanism заслонки турбонагнетателя
   5.19. The general check турбонагнетателя
   5.20. Removal and installation турбонагнетателя
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d Как делать ставки на футбольные матчи читайте здесь.
cacheman crack, to a in.
автоюрист пермь бесплатная консультация.
e2a7ff6d Как делать ставки на футбольные матчи читайте здесь.
cacheman crack, to a in.
автоюрист пермь бесплатная консультация.

5.16.3. A regulator of pressure of fuel

Removal and installation

PERFORMANCE ORDER
1. Remove pressure in fuel system.
2. Remove a wire of weight from the accumulator.
3. Lift the receiver an air inlet.
4. Remove a vacuum hose from a regulator of pressure of fuel.
5. Ослабьте a collar of fastening of a fuel hose, unscrew screws of fastening of a regulator of pressure and separate a regulator from a fuel highway, and then separate a regulator from returnable топливопровода.
6. Installation is made in sequence, return to removal. Thus it is necessary to establish new sealing rings and to grease with their thin butter layer.