Subaru Legacy

Since 1990-1998 of release

Repair and car operation

Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Pressure removal in fuel system
   5.4. Check of the fuel pump
   5.5. The fuel pump
   5.6. A fuel separator (only models 4WD)
   5.7. The gauge of level of fuel
   5.8. A fuel tank
   5.9. A casing of the air filter
   5.10. An accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of giving of air
   5.14. Electronic control system
   5.15. Check of system of injection of fuel
   - 5.16. Check and replacement of elements of system of injection of fuel
      5.16.1. The throttle case
      5.16.2. A fuel highway
      5.16.3. A regulator of pressure of fuel
      5.16.4. Fuel atomizers (MPFI)
      5.16.5. A fuel atomizer (SPFI)
      5.16.6. The control air valve (IAC)
      5.16.7. The gauge of position throttle заслонки (SPFI)
   5.17. Турбонагнетатель
   5.18. Check of the executive mechanism заслонки турбонагнетателя
   5.19. The general check турбонагнетателя
   5.20. Removal and installation турбонагнетателя
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment

e2a7ff6d мостбет зеркало официальный сайт IN-vid.
e2a7ff6d мостбет зеркало официальный сайт IN-vid.

5.16.2. A fuel highway

Details of fastening of a fuel highway

And – fastening screws топливопровода

In – bolts of fastening of a fuel highway

With – returnable топливопровод

Removal and installation

1. Remove pressure in fuel system. Remove a wire of weight from the accumulator.
2. Remove pipes and hoses which can interfere with removal of a fuel highway.
3. Disconnect electric sockets from fuel atomizers.
4. Unscrew screws and separate metal топливопроводы from a fuel highway.
5. Unscrew bolts, крепящие a fuel highway.
6. Remove a fuel highway together with atomizers from an inlet collector.
7. Installation is made in sequence, return to removal. At installation of fuel atomizers and at connection of pipelines to a fuel highway use new sealing rings.