Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
- 4. Heating, ventilation
   + 4.1. Cooling system
   + 4.2. Heating system
   - 4.3. Air central air
      4.3.1. Check of a central air of air
      4.3.2. Coolant addition
      4.3.3. The Receiver / a dehumidifier
      4.3.4. The compressor
      4.3.5. The condenser
      4.3.6. The evaporator
   4.4. Climate control system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

4.3.5. The condenser
THE GENERAL DATA

The condenser of a central air of air is established before a radiator.

Removal

PERFORMANCE ORDER
1. Discharge air central air.
2. Remove a lattice of a radiator and unscrew bolts of fastening of a radiator.
3. Disconnect pipes of a coolant from the condenser, having unscrewed bolts of fastening of a pipe on the left side of the condenser (drawing at the left) and on the right side of the condenser (drawing on the right).
4. Unscrew bolts of fastening of the condenser.
5. Incline a radiator back and take the condenser from the car.

Installation
The prevention

At installation of the new condenser it is necessary to establish a new receiver a dehumidifier.


PERFORMANCE ORDER
1. At installation of the new condenser merge from it oil in a measuring test tube. Fill in the same quantity of new oil in the new condenser.
2. Establish the condenser before a radiator and fix bolts.
3. Connect pipes to the condenser, preliminary having established on them new sealing rings of round section and having oiled them.
4. The further installation is made in sequence, return to removal.