Subaru Legacy

Since 1990-1998 of release

Repair and car operation

Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
- 4. Heating, ventilation
   + 4.1. Cooling system
   + 4.2. Heating system
   - 4.3. Air central air
      4.3.1. Check of a central air of air
      4.3.2. Coolant addition
      4.3.3. The Receiver / a dehumidifier
      4.3.4. The compressor
      4.3.5. The condenser
      4.3.6. The evaporator
   4.4. Climate control system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment

4.3.1. Check of a central air of air
1. Warm up the engine to normal working temperature.
2. Establish the handle of adjustment of temperature of a central air of air in position "cold air" and include the maximum speed of the fan.
3. After the beginning of work of a central air check up temperature of two pipes connected with the evaporator. More thin pipe going from a condenser exit to the evaporator should be very cold, and thicker tube going from an exit of the evaporator to the compressor, should be slightly colder.
4. Insert the thermometer into the central nozzle of giving of air and check up the temperature submitted a central air of air. The temperature of air submitted to salon of the car by a central air should be on 15-30 With more low, than air temperature.