Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
- 4. Heating, ventilation
   + 4.1. Cooling system
   - 4.2. Heating system
      4.2.1. The heater fan
      4.2.2. A heater radiator
      4.2.3. The control panel a heater
   + 4.3. Air central air
   4.4. Climate control system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


4.2.2. A heater radiator
THE GENERAL DATA

Heater

1 – a heater casing
2 – a heater radiator
3 – tubes of giving of air
4 – a branch pipe of giving of the warmed-up air
5 – заслонка
6 – заслонка
7 – заслонка
8 – заслонка
9 – заслонка
10 – заслонка the warmed-up air
11 – the lever
12 – the gate lever
13 – the gate lever
14 – the connection lever
15 – the lever
16 – the main draught
17 – the screw
18 – a spring
19 – the engine of the executive mechanism
20 – an arm of the engine of the executive mechanism
21 – draught of the executive mechanism
22 – draught
23 – draught
24 – the holder of draught
25 – скоба
26 – a clip
27 – a clip
28 – a suspension bracket
29 – draught
30 – a connector
31 – a connector
32 – the screw
33 – a suspension bracket
34 – the bottom air line
35 – the plug
36 – the bottom air line
37 – a draught casing

The prevention

On some models the safety air cushion is established. Therefore it is necessary to remove a wire of weight from the accumulator and to wait at least one minute before work about the gauge of collision or the panel of devices to avoid casual expansion of an air cushion of safety.


Removal

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Merge cooling liquid from cooling system.
3. Disconnect hoses of giving of a cooling liquid to a heater radiator.
4. Disconnect a cable of adjustment of temperature from a heater radiator.
5. Remove the central console and the panel of devices.
6. Separate the tube of a heater located between a radiator of a heater and the fan of a heater.
7. On models with air central air remove the evaporator.
8. Unscrew bolts (are specified by arrows).
9. Remove a heater and take it from the car.
Unscrew screws, крепящие clips of pipes of a radiator of a heater on the heater case (fig. the Heater see). Take a radiator of a heater from a heater casing.

Installation

PERFORMANCE ORDER
1. Establish a heater radiator in a heater casing.
2. Establish a heater in the car.
3. Establish heater tubules.
4. Repeatedly establish the panel of devices and the central console. Connect wires, a cable and the vacuum hoses separated at removal.
5. Establish a cable of adjustment of temperature.
6. Connect hoses of giving of a cooling liquid to a heater.
7. Fill in cooling liquid in system of cooling and connect a wire of weight of the accumulator.