Subaru Legacy

Since 1990-1998 of release

Repair and car operation

Subaru Legasi
+ 1.1. Identification numbers
- 2. Maintenance service
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Periodicity of service
   2.4. Check of level of engine oil
   2.5. Level of a cooling liquid
   2.6. Level of a brake liquid and a liquid of a drive of coupling
   2.7. A liquid for a windscreen washer
   2.8. Accumulator check
   2.9. Tyres and pressure check in tyres
   2.10. Check of level of oil in an automatic transmission
   2.11. Check of level of a liquid in the steering amplifier
   2.12. Replacement of oil and the oil filter
   2.13. Check and accumulator service
   2.14. Accumulator gymnastics
   2.15. Check of system of cooling
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tyres
   2.19. Suspension bracket and steering check
   2.20. Exhaust system check
   2.21. Check of level of oil in a transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of a manual brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement приводного a belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation картера (PCV)
   2.36. Check of system of catching of steams of fuel
   2.37. Check of system of repeated burning of the fulfilled gases (EGR)
   2.38. Service of system of cooling
   2.39. Replacement of a brake liquid
   2.40. Oil replacement in an automatic transmission
   2.41. Oil replacement in a mechanical transmission
   2.42. Check and adjustment of backlashes of valves
   + 2.43. The basic malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment

2.13. Check and accumulator service

Tools and the materials necessary for service of the accumulator

1 – the guard necessary that electrolit has not got on the person.
2 – soda. The soda diluted in water, is necessary for neutralisation of the poured electrolit.
3 – vaseline. It is used for protection of plugs of the accumulator against corrosion.
4 – a wire brush. It is necessary for removal of traces of corrosion from plugs of the accumulator and wires.
5 – plastic washers. Are established on the accumulator under plugs of wires.
6 – a stripper. It is used for removal of plugs from the accumulator.
7 – a version of the wire brush used for clearing of plugs of the accumulator.
8 – rubber gloves which are necessary for using at work with electrolit.

Corrosion of poles of the storage battery

Corrosion of poles of the storage battery is shown in the form of a friable white powder.

The prevention

The electrolit in the storage battery represents poisonous and corroding acid. Therefore it is necessary to avoid electrolit hit in eyes, on a skin, the painted surfaces and so on. In case of electrolit flood wash out made room by plentiful quantity of cold water. If the electrolit has got to eyes, after washing of eyes by water, immediately address to the doctor.

At work of the storage battery hydrogen is formed, therefore never it is impossible to smoke or address with open fire or sparkling substances in immediate proximity from the accumulator.

Always prior to the beginning of work on an electric equipment disconnect minus a wire from the accumulator. It will prevent occurrence unintentionally short circuits.

Never disconnect wires from the storage battery at the working engine.

Always disconnect wires from the storage battery if the gymnastics of the storage battery with application external зарядного devices are made.

Always disconnect wires from the storage battery and a wire from the generator for the period of car repairs with application of devices of electric welding.

Before the beginning of service of the accumulator gather all necessary tools and materials.

Cleanliness of the storage battery and, in particular, its external surface is especially important, as the layer of a dirt collecting on it easily forms electrospending lines which lead to the battery self-category. Cleanliness is important not only for a served accumulator room of the battery, together with for the unattended battery which, despite the name, is not absolutely unattended.

1. Remove plugs of a wire from the accumulator.
2. Using a metal brush, clear plugs of the accumulator and the plug of wires.
3. Clearing of plugs of the accumulator make before occurrence of light brilliant metal.
4. If necessary wash out plugs a soda solution in warm water. Be careful, that the soda solution has not got to accumulator banks.
5. Check up that nuts of a fixing element of the accumulator are reliably tightened. Do not draw a nut as the accumulator case can be damaged.
6. Before connection of clips of the accumulator grease plugs безкислотным with vaseline and anticorrosive компаундом.