Subaru Legacy

Since 1990-1998 of release

Repair and car operation

Subaru Legasi
+ 1.1. Identification numbers
- 2. Maintenance service
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Periodicity of service
   2.4. Check of level of engine oil
   2.5. Level of a cooling liquid
   2.6. Level of a brake liquid and a liquid of a drive of coupling
   2.7. A liquid for a windscreen washer
   2.8. Accumulator check
   2.9. Tyres and pressure check in tyres
   2.10. Check of level of oil in an automatic transmission
   2.11. Check of level of a liquid in the steering amplifier
   2.12. Replacement of oil and the oil filter
   2.13. Check and accumulator service
   2.14. Accumulator gymnastics
   2.15. Check of system of cooling
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tyres
   2.19. Suspension bracket and steering check
   2.20. Exhaust system check
   2.21. Check of level of oil in a transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of a manual brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement приводного a belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation картера (PCV)
   2.36. Check of system of catching of steams of fuel
   2.37. Check of system of repeated burning of the fulfilled gases (EGR)
   2.38. Service of system of cooling
   2.39. Replacement of a brake liquid
   2.40. Oil replacement in an automatic transmission
   2.41. Oil replacement in a mechanical transmission
   2.42. Check and adjustment of backlashes of valves
   + 2.43. The basic malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


2.10. Check of level of oil in an automatic transmission

Oil level in an automatic transmission is necessary for supporting constantly at demanded level. Too low level of oil can lead to infringement in twisting moment transfer, and too high level can lead всасыванию oils, to losses and even to transmission damage.

Щуп for measurement of level of oil in an automatic transmission it is located in the left back corner of a motor compartment.

1. Spend a trip on distance of 15-25 km to heat up a transmission to normal working temperature (70–80 ).
2. Establish the car on an equal horizontal surface.
3. Idling the engine, the tightened manual and foot brake, move the selector handle on all positions and return to a starting position (Park). In this position of the selector and the engine idling, take щуп for measurement of level of oil and simultaneously with a level mark estimate an oil condition.
4. Wipe щуп and establish it into place.
5. Repeatedly take щуп and measure oil level. If a transmission cold, oil level has to be between two bottom labels on щупе. If the transmission is heated-up to normal working temperature, oil level should be between two top labels on щупе.
6. If a transmission cold, oil level has to be between two bottom labels, and at a hot box – between two top labels.
7. If oil level low add it through an aperture for щупа.

The prevention

Never suppose, that oil level was more than the top label.

8. The distance between labels corresponds about 0,6 l of oil.
9. If black or brown, oil it is necessary to replace colour of oil. If you doubt quality of oil, compare the sample of fresh oil and the oil which are in a transmission.