Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. A suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   + 11.3. A forward rack
   - 11.4. A rack of a back suspension bracket
      11.4.1. The back stabilizer of cross-section stability
      11.4.2. The longitudinal lever of a back suspension bracket
      11.4.3. Cross-section levers of a back suspension bracket
      11.4.4. A nave of a back suspension bracket
      11.4.5. A fixing element of a back nave
   11.5. An air self-levelled suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

11.4.5. A fixing element of a back nave

Removal

PERFORMANCE ORDER
1. On models 4WD ослабьте a nut of fastening of a back power shaft to a nave.
2. Lift a back part of the car and fix on supports. Remove a back wheel.
3. On models with back brake drums remove a brake drum, brake колодки, disconnect a brake tube from the working brake cylinder and remove the brake cylinder.
4. On models with back disk brakes remove a support and, using a soft wire, suspend it to a back rack, remove the holder of a support, a brake disk and knot of a manual brake.
5. Separate a cable of a manual brake from a brake board.
6. On models with ABS unscrew a bolt and remove gauge ABS.
7. On models 2 WD remove a cap from the central part of a nave. Unscrew a nut of fastening of a nave and remove a back nave.
8. Unscrew 4 bolts and remove a brake board from a fixing element of a nave.
9. Unscrew the longitudinal lever of a back suspension bracket from a fixing element of a nave.
10. Disconnect cross-section levers of a back suspension bracket from a fixing element of a nave.
11. Unscrew bolts of fastening of a back rack to a fixing element of a nave.
12. Remove a fixing element of a nave. On models 4WD unscrew a nut of fastening of a back power shaft to a nave and take a power shaft from a nave.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal. Tighten the demanded moment bolts and nuts of fastening of levers of a back suspension bracket after car installation on wheels. On models with back brake drums remove air from hydraulic brake system.