Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. A suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   + 11.3. A forward rack
   - 11.4. A rack of a back suspension bracket
      11.4.1. The back stabilizer of cross-section stability
      11.4.2. The longitudinal lever of a back suspension bracket
      11.4.3. Cross-section levers of a back suspension bracket
      11.4.4. A nave of a back suspension bracket
      11.4.5. A fixing element of a back nave
   11.5. An air self-levelled suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


11.4.3. Cross-section levers of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports. Remove a back wheel.
2. On models 2WD remove a back part of an exhaust system.
3. On models with ABS remove a wire of the gauge from the longitudinal lever of a back suspension bracket.
4. Using a marker or a paint, put combination labels on a back adjusting bolt of the cross-section lever and a back beam.
5. Unscrew draught of the stabilizer from the back cross-section lever.
6. Unscrew a nut and take a bolt of fastening of cross-section levers to a fixing element of a nave.
7. Unscrew nuts and take bolts of fastening of the internal ends of cross-section levers to a back beam.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal. A tightening of bolts and nuts of fastening of cross-section levers of a back suspension bracket make after car installation on wheels. Check up and, if necessary, adjust corners of installation of back wheels.