Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. A suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   - 11.3. A forward rack
      11.3.1. Repair of a forward rack
      11.3.2. The forward stabilizer of cross-section stability
      11.3.3. The bottom lever of a forward suspension bracket
      11.3.4. Replacement of the bottom hinge of a forward suspension bracket
      11.3.5. A rotary fist
   + 11.4. A rack of a back suspension bracket
   11.5. An air self-levelled suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment


e2a7ff6d e2a7ff6d

11.3.5. A rotary fist

Removal

PERFORMANCE ORDER
1. Ослабьте a nut of fastening of a power shaft to a nave.
2. Lift a forward part of the car and fix on supports.
3. Remove a support, brake колодки, the holder of a support and a brake disk.
4. On models with ABS unscrew a bolt and remove gauge ABS.
5. Unscrew a nut of fastening of steering bent for to a rotary fist and, using a stripper, take the spherical hinge of steering draught from a rotary fist.
6. Ослабьте nuts of fastening of a forward rack to a rotary fist, preliminary having noted an arrangement of the top bolt in relation to a forward rack.
7. Unscrew a coupling bolt of fastening of the spherical hinge to the bottom lever of a forward suspension bracket.
8. Using mount, take the spherical hinge of the bottom lever from a rotary fist.
9. Unscrew bolts of fastening of a forward rack to a rotary fist.
10. Unscrew a nut of fastening of a power shaft to a nave. Take a power shaft from a nave, taking away a rotary fist from the car.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Thus the top bolt of fastening of a rotary fist to a rack is necessary for establishing in the same position, as before removal.
3. Check up and, if necessary, adjust corners of installation of wheels.