Subaru Legacy

Since 1990-1998 of release

Repair and car operation

Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement brake колодок on disk brakes
   10.4. A support of disk brakes
   10.5. A brake disk
   10.6. Replacement brake колодок drum-type brakes
   10.7. The working brake cylinder
   10.8. The main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of a regulator of pressure
   10.11. Prorolling of hydraulic brake system
   10.12. Adjustment of a manual brake
   10.13. Replacement of a cable of a manual brake
   10.14. Replacement brake колодок a manual brake on back disk brakes
   10.15. Additional brake system
   10.16. The vacuum amplifier of brakes
   10.17. The stoplight switch
   10.18. Antiblocking system of brakes (ABS)
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment

10.5. A brake disk

THE GENERAL DATA

Arrangement of bolts of fastening of the holder of a support of a forward wheel

Arrangement of bolts of fastening of the holder of a support of a back wheel

Check

PERFORMANCE ORDER

1. Lift accordingly a forward or back part of the car and fix on supports. Remove a corresponding wheel.

2. Remove a support and, using a soft wire, adhere it to a rack, without disconnecting from it a brake hose.

3. Establish under nuts of fastening of a wheel of a washer in the thickness of 10 mm and screw nuts of fastening of a wheel.

4. The indicator of hour type check up palpation of a brake disk. The indicator of hour type fix in any convenient place and, turning a disk, define its palpation on distance of 10 mm from external edge.

5. Clear a working surface of a brake disk a small emery paper.

6. Slowly turn a brake disk so that it could be considered from two parties. Measure a thickness of a brake disk. Deterioration of a brake disk from колодок should be in admissible limits. If deterioration exceeds an admissible limit or there are cracks on a disk, the disk is subject to replacement (the minimum thickness of a brake disk is beaten out on an internal surface of a brake disk – on the right).

Removal

PERFORMANCE ORDER

1. Unscrew nuts of fastening of a wheel with thick washers which were established at check of palpation of a disk.

2. Unscrew two bolts and remove the holder of a support (fig. the Arrangement of bolts of fastening of the holder of a support of a forward wheel, the Arrangement of bolts of fastening of the holder of a support of a back wheel see ).

3. Remove a brake disk.

Installation

PERFORMANCE ORDER

1. Clear a brake disk and establish it into place.

2. Establish the holder of a support and fix bolts.

3. Establish brake колодки and a support.

4. Establish a wheel and lower the car. Some times press a brake pedal that brake колодки have nestled on a brake disk.